8 Piece Retention Wall System: (Patent pending)
- Rotomolded Polyethylene w/UV protection (Corrosion proof)
- 72.5" long x 30" high x 3" wide x 1/8"+ thick
- Approximately 50lbs per piece
- Patented "Mow Edge" to avoid damaging safety pads while mowing.
- Patented "Performance Venting integrated into the walls.
- 1 person - 10 minute wall and frame assembly. (Compared to 3.5 hours + for competitors)
15' Round Frame:
- 13 Gauge steel frame grey powder coated & galvanized
- 8 Piece top frame & legs pre-installed in the retention walls
- Top frame - 1.9" OD
- Legs - 1.5" OD. (Legs go down through the retention wall and out the bottom with a welded-on leg plate. (Actual trampoline frame is supported by the legs, not by resting on the retention wall.)
Jumping Mat:
- 13' Diameter, UV protected polypropylene
- 10 Rows of stitching (6 rows on the mat, then 4 more rows over the SunGuard UV protection strip
- 35lb UV resistant test thread
- 96 - 5.0 mm V-rings (spring hooks)
- 1.5" UV resistant strapping to sew the V-rings to the jumping mat fabric.
Safety Pads:
- 15' Outside diameter
- 11.5" wide
- .75" thick, high density foam padding
- 18 oz. Marine Grade vinyl coated Polyester w/UV protection.
- 16 - 1" wide tie straps at frame with quick clip connectors
- 16 Spring loops sewn to underside of pads to keep the wind from blowing the pads up.
96 Springs:
- 8.5" Springs
- 3.15mm Hard Drawn
- Active coils 54 REF RH
- Each end 5-6 tapered coils
- Initial tension after stress relief 18-22 pound (8.15kg - 10kg)
- Stress Relief at 500F
- Zink Plate
- Spring is stretched to 10.5" when installed, resulting in 2" of spring load.
Order Now